Services
AI & Software
Solutions
Training
Tools
Insights
References
Contact
Free initial consultation Ask a first question by email
About Deutsch
← AI & Software

Spare parts by 3D design & printing

Measure a broken or discontinued part, model it in 3D, check tolerances and print it. With clear limits on intellectual property and safety parts.

A handle on a machine breaks, the part is no longer available, the vendor has ended the series. For a plastic bracket that is no reason to stop the line. For a load-bearing component it is.

How I work: with source · with approval · in your system.

Starting point

Many spare parts are simple plastic or aluminium pieces: brackets, covers, bushings, handles. The drawing is missing, the original is worn or broken. Without a sample, reproduction is difficult; with a sample, it is often feasible.

What I do

I measure the part or its counterpart, model it and check tolerances before printing. Where no drawing exists and measuring the broken piece is not enough, analysis from reverse engineering comes in. Then comes the print, in a small series if needed. The check runs against the critical dimensions, not just visually.

The process is in place and running: measure or reconstruct, design, check tolerances, print. A photo of a printed part follows shortly; until then there is no example here, because an invented one would be worse than none.

Result

An STL or 3MF model, the printed part and a short measurement record. For a small series, the parameters that make the part reproducible.

Example

The process in short: review the part and its installation, measure, design the model, check mesh and dimensions, test print and fit, correct, deliver. A photographed example follows once the first part is documented.

Limit

The original manufacturer’s intellectual property remains: design, patent and trademark must be respected. I do not take on safety-related parts, including load-bearing components, pressure vessels, parts with heat input, vehicle and medical technology. Whether a part falls into these categories is settled before design, not after.

How it runs

  1. Review the part and its installation, clarify limits
  2. Measure or reconstruct from existing data, via reverse engineering when no drawing exists
  3. Model it, check mesh and dimensions
  4. Test print, check fit, correct the model
  5. Deliver the part or small series, record the dimensions

Common questions

How does a first job run?

Look at the part and how it is installed, clarify the limits, then measure or reconstruct, design, test print, check the fit. A photographed example appears here once the first part is documented.

Which materials are possible?

Plastic for prototypes and non-load-bearing parts. Higher requirements become a question of process and material, not just the printer.

Can a cracked part be copied?

Often yes, if the fracture surfaces are complete and the part carries no hidden stress. If a piece is missing, it is reconstructed and the fit checked against the counterpart.

What about parts that are still available?

Then buy them. A reprint makes sense when lead time, price or availability prevent it.

The next step costs nothing.

30 to 60 minutes, no strings attached: where is the biggest friction, what is the most effective lever, and is a collaboration a fit?